The main products of our factory are medium frequency hydraulic pipe bender, hydraulic pipe bender, cold drawing tee and other pipe fittings.Can produce the largest diameter, the maximum thickness (Ф 21-1620 - mm) of expanding and bend production equipment, products widely used in petrochemical, electric power industry, boiler, steel tube expanding industry, shipbuilding industry, etc. The components of the pipe fitting equipment:
Elbow pusher main machine, hydraulic pump station, operation station, motor control cabinet, intermediate frequency power supply, compensation capacitor, water cable, intermediate frequency coil adjusting frame, reactor.
Working principle of the equipment:
Set the cut raw materials on the elbow mold core rod, put the intermediate frequency induction line trap at the end of the elbow mold core, start the cooling water pump and intermediate frequency power supply, heat the raw materials to about 800°C, then start the pushing machine to push the elbow.
Select the main push pump according to the pushed elbow and select the feeding speed. The mandrel is heated to the working temperature and begins to push. During the working, the pushing speed can be adjusted.Note: when the main pump work can be used at the same time, generally only one can be used.It can also be used to step back without stopping.The back pump cannot be used at the same time, only one can be started and the other can be used as a backup.Feeding pump can only be used when feeding.The safety pressure of the hydraulic system of the main oil pump shall be set as, and the safety pressure of the hydraulic system of the auxiliary oil cylinder shall be set as.There is a travel switch at both ends of the push machine stroke, the actual stroke should be less than the maximum stroke, that is, the active push plate before and after both ends from the actual end of the margin, so as not to run the cylinder piston to
The components of the pipe fitting equipment:
Intermediate frequency pushing machine main machine, hydraulic pump station, operation station, motor control cabinet, intermediate frequency power supply, compensation capacitor, water cable, intermediate frequency coil adjusting frame, reactor.
Working principle of the equipment:
Set the cut raw materials on the elbow mold core rod, put the intermediate frequency induction line trap at the end of the elbow mold core, start the cooling water pump and intermediate frequency power supply, heat the raw materials to about 800°C, then start the pushing machine to push the elbow.
Select the main push pump according to the pushed elbow, select the feeding speed, the sluice gate and the mandrel to be heated to the working temperature, and start pushing. During the working, the pushing speed can be adjusted. Push to the middle point, the pusher stops automatically, the hydraulic sluice gate dies, the mandrel is loaded, release the sluice gate and go back to the end point.Note: when the main pump work can be used at the same time, generally only one can be used.It can also be used to step back without stopping.The back pump cannot be used at the same time, only one can be started and the other can be used as a backup.Feeding pump can only be used when feeding.The safety pressure of the hydraulic system of the main oil pump shall be set as, and the safety pressure of the hydraulic system of the auxiliary oil cylinder shall be set as.There is a travel switch at both ends of the push machine stroke, the actual stroke should be less than the maximum stroke, that is, the active push plate before and after both ends from the actual end of the margin, so as not to run the cylinder piston to.
Cangzhou Aoguang mechanical Equipment Co., LTD not only produces elbow machine, but also produces pipe bending machine, tee machine, pipe expanding machine, press machine, bevel machine and other mechanical equipment as well as supporting molds.
|
