The company mainly produces pushing machine, tee machine, pipe bending machine, pipe expanding machine, press machine, bevel machine and other pipe fitting equipment and all the molds.

The following is a brief introduction to the pusher: pusher machine pull clamp die fixed mandrel.Put the pusher clamping die in and then install the fixed mandrel.According to the customer needs of the wall thickness and diameter of the selection and die core.

Pusher machine can produce all models with outer diameter of 21-1620mm and wall thickness of 3-120 or above.We can also customize directly according to the customer's requirements.

The simple composition of pusher: hydraulic pump station, operating table, motor control cabinet, intermediate frequency power supply, compensation fuse, water cable, intermediate frequency coil adjusting frame, reactor and so on.

Advantages of pushing machine: low price, guaranteed quality and high production efficiency.

Elbow machine is also called push machine, push machine on the skateboard and the position of the axis are not in the origin of the state, work back to the origin program.

Push the machine after the start of the empty operation 1-2 minutes, on the skateboard full stroke movement 2 to 3 times, if found abnormal sound or have problems should park the car, clean the problem, all normal before the operation.

Push machine operation should be unified by 1 person command, so that the operator and the feeding limit personnel close cooperation, to ensure that the cooperation personnel are in the safe direction to announce the bending signal.It is necessary to compacting the sheet when bending, in case the sheet becomes warped and hurts people.It is necessary to cut off the power supply when the die is adjusted.When changing the opening of the variable die, do not allow any material to contact with the die.

When the carbon steel elbow  machine tool is working, the rear part of the machine tool is not allowed to stand.Stop pressing the sheet at one end alone.If the workpiece or mold is found to be out of alignment during operation, parking and proofreading should be performed to prevent hand damage.To prevent excessive thickness of iron plate or quenched steel plate, high-grade alloy steel, square steel and sheet material beyond the performance of sheet bending machine, so as not to damage the machine.Often check the upper and lower mold fit;Is the gauge indication in accordance with the regulations?Abnormal immediately stop, see the reason and timely cleaning.Before the elbow is turned off, a wooden block should be placed on the lower die below the oil cylinder on both sides to lower the upper slide onto the wooden block.First exit the control system program, then shut off the power supply.