• - Cold Forming Elbow Machine
• - Hot Forming Elbow Machine

• - Pipe End Expanding Machine
• - Full Length Pipe Expander

• - Single-Head Pipe Fittings Beveling Machine
• - Automatic Double-Head Elbow Beveling Machine
• - Automatic Triple-Head Tee Beveling Machine
• - Large Steel Pipes Beveling Machine

Our company is the production of pipe fittings machinery, pipe fittings machinery in the elbow push machine is mainly a kind of equipment for the production of pipe fittings elbow.Suitable for the production of 21mm-1620mm elbow, the production material is carbon steel and alloy steel, etc.Elbow push machine is a traditional machine, and it is also one of the most exported pipe fittings equipment in our company.Elbow push system machine mainly includes: alloy core head, intermediate frequency coil, export support, push the door, open hydraulic oil cylinder, push plate, hydraulic lift cylinder, the main oil cylinder, cylinder bracket, after feeding, feeding core rod, the big chassis, oil cylinder bracket, motor, axial plunger pump, integrated block (which installation of the hydraulic control valve), etc

How to operate elbow push machine normally

Before the elbow pushing machine works, check whether the electrical switch, travel limit is safe and reliable, whether the operation is flexible, whether the safety protection device is safe and reliable.Check the oil level gauge on the side of the elbow pushing machine to see if the hydraulic oil has reached the red line.Check whether the oil pressure valve is in normal condition. The stopper must touch the rear limit.Determine if the above is consistent.Install the mold and adjust the clearance.When installing the mould, it is necessary to install half of the lower mould first. After adjusting the upper and lower mould well, check whether the Angle between the upper and lower mould and the rotary table is deviated, and then move the main cylinder forward to push the material rod and feed mould on the straight line.After confirming that the above parts are normal, now start work.In the work, it is strictly prohibited to use beyond the pushing range of the elbow pushing machine, and the sliding plate of the machine tool should be lubricated.Pipe fittings to be pushed must be lubricated.In the work of attention to focus, to cooperate with each other, coordination.If the billet and equipment or the mould are found to be stuck in the process of pushing the elbow pushing machine, it shall stop the machine in time to check the reason or repair it in time.

2802-2803.