• - Cold Forming Elbow Machine
• - Hot Forming Elbow Machine

• - Pipe End Expanding Machine
• - Full Length Pipe Expander

• - Single-Head Pipe Fittings Beveling Machine
• - Automatic Double-Head Elbow Beveling Machine
• - Automatic Triple-Head Tee Beveling Machine
• - Large Steel Pipes Beveling Machine

Steps of using induction heating elbow machine

Steps of using induction heating elbow machine:
1. Reference electric pump manual.
2. The hydraulic cylinder is screwed into a box, the rear end of the cylinder is fastened to the bracket.
According to the outer diameter of the pipe, choose to die, set in the plunger. The roller is arranged on the die groove corresponding. And then put into the hole of the pattern size, then cover plate. The steel pipe is put into the slot. The rapid joint (high pressure oil at the bottom) playback in the operating cylinder joint oil screw. Put on the electric oil pump and tighten. Then we can bend the pipe. The finished pipe, unscrew the oil screw plunger, automatic reset.
Using induction heating elbow machine matters needing attention：
1, According to the electric pump manual.
2, Do not remove the quick connector
3, The use of oil as a induction heating elbow machine, the cleaning time, avoid plugging and oil spills.