The preparation work before the operation of the push machine is very important and must be carried out in strict accordance with the requirements to ensure the stability and work efficiency of the machine. The following will be a detailed introduction to the preparatory work before the operation of the push machine, no less than 2000 words for reference.
Step 1: Check the device
The equipment must be checked before the operation begins. First of all, check the appearance of the machine, whether there is damage or deformation. Then, check whether the power supply and plug of the device are normal. If there is any problem, it must be repaired or replaced in time to ensure that the machine can work properly.
Step 2: Clean the equipment
The equipment must be cleaned before operation can begin. First of all, the appearance of the machine should be cleaned, including the fuselage, control panel, workbench, etc., to ensure the cleanliness of the equipment. Then, clean the inside of the equipment, including the feed port, the discharge port, the cutter, etc. When using cleaning cloth and cleaning liquid to clean equipment, be sure to pay attention to safety.
Step 3: Calibrate the equipment
The equipment must be corrected before operation can begin. First of all, check whether the speed and strength of the equipment meet the requirements, and make corresponding adjustments. Then, check that the parameters of the device are set correctly. If you need to correct the equipment, follow the operation manual to ensure that the equipment can work properly.
Step 4: Insert the knife
The correct tool must be inserted before starting the operation. First check whether the tool is clean. Then, according to the hardness of the material and cutting requirements to choose the appropriate tool, insert the machine. Be sure to pay attention to safety when inserting knives to avoid injury to hands or other parts.
Step 5: Adjust the inlet and outlet
The position of the inlet and outlet must be adjusted before the operation begins. Adjust according to the size and shape of the material, cutting requirements, etc. Make sure the material can enter and exit smoothly, while avoiding material sticking or sliding.
Step 6: Turn on the device
After completing the above preparations, you can start the device. First, turn on the power supply, and then follow the operation manual to start the operation. When starting the device, be sure to pay attention to safety and avoid injuries to your hands or other parts.
In summary, the preparation work before the operation of the push machine is very important and must be carefully carried out. Carefully inspect the equipment, clean the equipment, correct the equipment, insert the tool, adjust the inlet and outlet, open the equipment, these steps can not be omitted. There is sufficient preparation to ensure the stability and efficiency of the equipment.
For more information about the push machine, please pay attention to our website: http://www.fitting-equipment.com
| 