• - Cold Forming Elbow Machine
• - Hot Forming Elbow Machine

• - Pipe End Expanding Machine
• - Full Length Pipe Expander

• - Single-Head Pipe Fittings Beveling Machine
• - Automatic Double-Head Elbow Beveling Machine
• - Automatic Triple-Head Tee Beveling Machine
• - Large Steel Pipes Beveling Machine

The purpose of the utility model is to solve the shortcomings of the size and precision of the tee in the existing technology, and put forward an automatic cold extrusion tee machine.  In order to achieve the purpose, the utility model adopts the following technical scheme:  

Design of a fully automatic machine, cold extrusion tee including workbench, the workbench upper end fixed a u-shaped rack installation, U top mounting bracket and are fixed on both sides with hydraulic cylinder, hydraulic cylinder are connected with the output shaft described each punch, punch set of punch, are installed on top of the workbench fixed template, template top has a cavity, the cavity content blank piece is placed,  On both sides of the top blank piece card has a fixed plate, punch through the template and ends on the blank piece, introduced the punch on the top of the blank piece above middle, are equipped with pressure sensors on each of the hydraulic cylinder, cavity wall equipped with infrared sensors, workbench wall equipped with PLC controller and the control panel, control panel is equipped with LCD screen,  The pressure sensor and the infrared sensor are connected with the PLC controller through wires, and the PLC controller is connected with the control panel through wires.  

Above introduction punch cover is fixed on both sides of the fixed plate, template top four corners and u-shaped installation frame is connected with the guide column, the fixed plate four corners are inserted on the guide column and can slide along the relative.  

The middle of the top surface of the table is provided with a groove, and the groove is fixed in the top of the ejection mechanism, and the upper end of the ejection mechanism runs through the template and aims at the bottom of the blank.  The bottom four corners of the table are fixed with anti-skid gaskets.  

The company introduces the new automatic cold extrusion three-way machine, the beneficial effect lies in:  In the traditional cold extrusion tee machine installed programmable logic controller, infrared sensor and pressure sensor, can accurate judgment of blank size and location, and observe the size of the extrusion pressure, greatly improving the forming of tee precision and operational performance, and greatly reduces the work strength, make staff work more easy operation.