| Operating precautions for the elbow beveling machine The following is an introduction by our company regarding the operation precautions and instructions for the elbow beveling machine. We hope this can be helpful to customers using the elbow beveling machine and bring them some assistance. Before operating the elbow beveling machine, the operator needs to receive training on the machine. The elbow beveling machine utilizes the rolling shear principle. During the rotation of the roller and the relative movement of the steel plate, the edges and corners of the steel plate are cut to the angle required by the customer. The elbow beveling machine can also process bevels for elbows, trunks, reducers, pipe caps, etc., according to the customer's required angle. The angle for processing the above pipe fittings and pipe diameters must also be taken into account. The elbow beveling machine needs to have a smooth surface when processing the pipe fittings. Compared with the separate beveling method, this machine has lower energy consumption, three times faster beveling speed, and no need for cleaning burrs. This elbow beveling machine has the advantages of low purchase price, small floor space, energy saving, simple operation, and high efficiency when ordered by our company. It can process the bevels of pipe fittings, steel pipes, and steel plates to the required angle by the customer. During the use of the beveling machine, the following points should be noted: Before starting the beveling machine, there should be no other items nearby to avoid affecting the normal operation of the machine; the operator's hands and body should be away from the beveling machine to avoid injuring the operator during the operation of the beveling machine. In severe cases, it may cause amputation of the arm or body, just like a mixer. The knife head is very sharp and must be operated carefully; before using the machine, it is necessary to check whether the beveling machine is complete and undamaged, whether the size and model of the pipe and the machine are compatible, and whether the clamping plates and the machine and the pipe are consistent and compatible; before starting the machine, check whether there are burrs, debris, or anything that may affect the use of the machine. If there is anything, clean it up properly in a stable and power-off state to ensure the smooth operation of the machine; before operating the machine, check if the power cord is damaged. If it is damaged, it must be repaired before use. Do not operate if the power cord is too short. You must get a longer external power cord to continue using it; after operating the beveling machine, immediately cut off the power, unplug the plug, and then touch the machine. Clean the pipe, wipe the machine, and put it back in place. |
